Instruction Manual

ENGLISH
Chapter 5: KGUARD Web Client
86
DVR User’s Manual
Seng Up with PPPoE
If your network uses the Point-to-Point Protocol over Ethernet (PPPoE), do the following:
1 On the Main Menu, click Remote Seng.
2 On the le panel, click Network > Network. The Network screen appears.
3 On Type, select PPPoE.
4 Specify the Client Port and HTTP Port.
Note:
• Obtain these informaon from your network administrator or your Internet Service Provider (ISP).
• If you cannot use the either of the two default ports, 80 or 9000, the specied port may be occupied by other
programs or it is being blocked by your service provider. Enter other port number. In this case, you need to
add the port number aer the IP address. For example, if you set the HTTP Port as 85, you need to enter the
IP address as “192.168.3.103:85”.
5 Enter the User Name and Password.
6 If necessary, specify DNS 1 and DNS 2.
7 Enable UPnP if you are using Universal Plug and Play (UPnP) devices.
8 Aer all sengs are complete, click Save.
« TIP »
To cancel any modicaons and retain the exisng sengs, click Refresh.