WINDOW/WALL - TYPE ROOM AIR CONDITIONER MULTI-STEP SPEED ELECTRONIC CONTROL TA B L E O F C O N T E N T S Important Safety Instructions ..........................1-3 Installation Instructions .................................... 4-8 Normal Sounds .................................................9 Air Conditioner Features .............................. 9-11 Care and Cleaning ......................................11-12 Troubleshooting Tip .....................................
IMPORTANT SAFETY INSTRUCTIONS READ THIS MANUAL Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner. You'll find many answers to common problems in the chart of troubleshooting tips. If you review our chart of Troubleshooting Tips first, you may not need to call for service at all.
IMPORTANT SAFETY INSTRUCTIONS CAUTION ! When the air filter is to be removed, do not touch the metal parts of the unit. It may cause an injury. Do not put a pet or house plant where it will be exposed to direct air flow. This could injure the pet or plant. Do not use strong detergent such as wax or thinner but use a soft cloth. Appearance may be deteriorated due to change of product color or scratching of its surface. Do not clean the air conditioner with water.
IMPORTANT SAFETY INSTRUCTIONS WARNING NOTE: The power supply cord with this air conditioner contains a current detection device designed to reduce the risk of fire. Please refer to the section Operation of Current Device for details.In the event that the power supply cord is damaged, it cannot be repaired-it must be replaced with a cord from the Product Manufacturer. WARNING Avoid fire hazard or electric shock. Do not use an extension cord or an adaptor plug. Do not remove any prong from the power cord.
INSTALLATION INSTRUCTIONS CAUTION BEFORE YOU BEGIN Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. Read these instructions completely and carefully. IMPORTANT- Save these instructions for local inspector s use. IMPORTANT- Observe all governing codes and ordianaces. Note to Installer- Be sure to leave these instructions with the Consumer. Note to Consumer- Keep these instructions for futrue reference.
INSTALLATION INSTRUCTIONS 1 C: Align the hole in the top rail with those in the top of the unit as shown in Fig.B PREPARE THE WINDOW Lower sash must open sufficiently to allow a clear vertical opening (H) of following size (see Table 1). Side louvers and the rear of the AC must have clear air space to allow enough airflow through the condenser,for heat removal. The rear of the unit must be outdoors, not inside a building or garage. Fig.
INSTALLATION INSTRUCTIONS B. Slide the free end "Ⅰ" section of the panel directly into the cabinet as shown in Fig. 2. Slide the panel down. Be sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet. 4 SECURE THE ACCORDION PANELS A.Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (Fig.5). Carefully close the window behind the top rail of the unit.
INSTALLATION INSTRUCTIONS B.Drive 3/4" (19mm) or 1/2" (12.7mm) locking screws through frame holes into window sash (Fig.8). Fig.8 C.To secure lower sash in place, attach right angle sash lock with 3/4" (19mm) or 1/2" (12.7mm) screw as shown(Fig.9). 1 1 2 2 3 4 5 3 6 7 4 8 9 10 5 11 12 6 13 14 15 16 17 Measure the inner width of the side curtain Fig.11 Fig.9 D.Cut Window sash seal foam and insert it in the space between the upper and lower sashes (Fig.10). FOAM SEAL or Fig.
INSTALLATION INSTRUCTIONS 7 INSTALL WEATHER STRIPPING (only be applicable to Energy star models ) If AC is Blocked by Stor m Window Add wood as shown in Fig.15, or remove storm window before air conditioner is installed. In order to minimize air leaks between the room air conditoner and the window opening, trim the weather sttipping with a proper length, peel off the protective backing and plug any gaps if needed (Fig.14).
NORMAL SOUNDS High Pitched Chatter High efficiency compressors may have a high pitched chatter during the cooling cycle. Vibration Unit may vibrate and make noise because of poor wall or window construction or incorrect installation. Sound of Rushing Air At the front of the unit, you may hear the sound of rushing air being moved by the fan Pinging or Switching Droplets of water hitting condenser during normal operation may cause pinging or switching sounds.
AIR CONDITIONER FEATURES TO ADJUST FAN SPEEDS: TO SELECT THE OPERATING MODE: Press to select the Fan Speed in four steps-Auto, Low, Med or High. Each time the button is pressed, the fan speed mode is shifted. On Dry mode,the fan speed is controlled at Low automatically. To choose operating mode, press Mode button.Each time you press the button, a mode is selected in a sequence that goes from Auto, Cool, Dry and Fan. The indicator light beside will be illuminated and remained on once the mode is selected.
AIR CONDITIONER FEATURES DISPLAYS: Fresh Air Vent Control (on 10000~12000Btu/h models): Displays Temp Temp Timer Timer DISPLAYS: Shows the set temperature in " OC" or " OF" and the Auto-timer settings.While on Fan only mode,it shows the room temperature. Error codes: AS-Room temperature sensor error-Unplug the unit and plug it back in.If error repeats, call for service. NOTE:In Fan only mode,it will display"LO" or "HI". -Evaporator temperature sensor error-Unplug the unit and plug it back in.
CARE AND CLEANING Cabinet Cleaning Air Filter Cleaning Push the vent handle to the Vent Closed position (where applicable). Open the front panel. Take the filter by the center and pull up and out. Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of warm water and mild liquid dishwashing detergent. Rinse thoroughly and wipe dry.
TROUBLESHOOTING TIPS Problem Air conditioner cooling, but room is too warm- NO ice forming on cooling coil behind decorative front. Solution Dirty air filter- air restricted. Clean air filter. Refer to Care and Cleaning section. Temperature is set too High, set temperature to a Lower setting. Air directional louvers positioned improperly. Position louvers for better air distribution. Front of units is blocked by drapes, blinds, furniture, etc. - restricts air distribution.
The design and specifications are subject to change without prior notice for product improvement. Consult with the sales agency or manufacturer for details.
