Use and Care Manual

5
INSTALLATION INSTRUCTIONS
PREPARE THE WINDOW
3/4 (or 1 / )
Screws
(7)
2
Lock Frame
(2)
Sash Lock
(1)
Mounting Hardware
Window sash
seal fo am
(1)
PREPARE AIR CONDITIONER
C: Align the hole in the top rail with those in the top
of the unit as shown in Fig.B
D: Secure the top rail to the unit with the 3/8 S crews
as shown in Fig.C.
For safety reasons, all four(4) screws MUST
be securely fastened.
NOTE:
INSTALL THE ACCORDION PANELS
NOTE: Top rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of (5/16 ).
This is necessary for prope r condensed water
utilization and dr ainage. If you are not u sing the Side
Pan els for any reason, th is pitch to the r ear must b e
maintained.
A.Place unit on floor, a bench or
a table. Hold th e Accordion
Panel in one hand and gently
pull back the center to free the
open end. See Fig.1
Fig.1
Lower sash must open sufficiently to allow a clear
vertical opening of 13 inches (330mm). Side louvers
and the rear of the AC must have clear air space to
allow enough airflow through the condenser, for heat
removal. The rear of the unit must be outdoors, not
inside a building or garage.
A: Remove the air conditioner from the carton and
place on a flat surface.
B: Remove top rail from the rear of the packaging
material as shown in Fig. A.
Packaging
Fig.
A
Top R ail
Fig.B
Fig.C
Top Rail Hardware
3/8 Screws
(4)
Top Rail
(1)
or
Top Rail Hardware
3/8 Screws
(4)
Top Rail
(1)
or