Instructions / Assembly
7
7. button
6. button
Press this button to enter sleep mode, which the unit will exit after
8 hours of continuous operation and restore to the previous status.
Note With the unit on, press this button to set off timer.
With the unit off, press this button to set on timer.
:
Note: The SLEEP function can not be activated in fan and dry mode.
Control Panel
Press this button, the indicator light will illuminate.
8. button
Press the "timer" button, the timer indicator light illuminates.
b. Press (-)or (+) button to select the desired time.
c. After setting time 5 seconds without other operation, the timing function will be
initiated automatically. If you press the timer button, there are no operation within 5
seconds or setting time is 0, the timing function will be cancelled automatically.
d. When the timing function is initiated, the unit displays the remaining time by press
the "timer" button once and cancel the timing function by press it again.
a.
Guide of customer
1.Install the mobile air conditioner in a flat
and spacious location where the air outlets
will not be obstructed.
2.A minimum clearance from walls or other
obstacles should be kept, as fig.
3.The gradient can't be more than 10 degrees
with the horizontal plane, while putting
and using the utensil.
●The customer should have a qualified power supply coincident with that printed on
the tag of the air conditioner.
●Must use special circuit and efficient grounding outlet matching with the plug of the
air conditioner.
●The appliance should be installed in accordance with national wiring regulation.
●The plug should be easily accessible after installation.
M
o
r
e t
h
an 50c
m
Select a best location
M
o
r
e t
ha
n 6
0c
m
Note: 1.The air conditioner shall not be used in the laundry.
2.The plug shall be accessible after the unit is positioned.
1. Install the adaptor A and adaptor B( ) onto the e
as shown in Fig.A or Fig.B .
flat mouth or round mouth xhaust duct
Duct mount instruction
=
( flat mouth)
(Be used to install to the window)
Fig.A
(round mouth)
or
=
(Be used to install to the wall (only for some units))
Fig.B
·In cooling, heating and drying mode, the exhaust duct needs to be installed while in
fan mode, the exhaust duct is not needed.
·According to the actual needs, the exhaust duct can be moderately compressed and
tensed, but cannot be arbitrarily stretched and bent.
·The exhaust duct can be connected with Windows or installed into the wall.
Based on accessories of the unit you buy and the actual needs, you can make the
installation.
Installation
10
4. (-) or (+) button
a. Each time the (+) or (-) button is pressed, the setting temperature will increase or
decrease by 1℃(1℉). The setting temperature ranges from 16℃ (60℉)～32℃(90℉).
b. By pressing both the (-)and (+)button at the same time(≥3s), the display will
toggle between Celsius and Fahrenheit.
5. button
The mode indicator light illuminates under the different mode.
Press this button, you can select the running mode as follows:
Note: HEAT mode is not available for cool only units.
auto cool dry fan heat
/
/
/
/