Instructions / Assembly

Control Panel
6
1. button
Press this button to make the unit run or stop.
TEMP. indicator
Function buttons
*1.In auto, cool and heat mode, TEMP.indicator display is setting temperature.
2.In dry and fan mode, TEMP.indicator display is room temperature.
* In cooling or heating mode, when or button is pressed, the setting temperature is
displayed and be adjusted.
TEMP. indicator
123
4
5
6
7
8
3. button
Press this button, you can select the fan speed as follows:
The fan speed indicator light illuminates under the different fan speed.
2. button
auto hi med low
a. The running time of the unit has reached 250 hours, the filter reset indicator light will
illuminates, and it means the air filter should be cleaned.
After cleaning, you can press the “filter reset” button, the filter reset indicator light will
turns off and the running time will be cleared.
b. If you do not press the “filter reset” button when the filter reset indicator light
illuminates, the indicator light will always illuminates except the unit is power off.
Note: In fan mode,do not have auto fan speed;
Installation
11
FigB
-
+
AUTO AUTO
SWING TIM ER SLEEP
MODE
FAN SPEED
FILTER
RESET
TEMP. indicator
123
4
5
6
7
8
There are two kinds about control panel, Fig A and Fig B, the actual shape shall prevail.
FigA
/
/
/
2. Connect the exhaust duct to the Air outlet connector on back of the unit. Slide-in the
adaptor A downwards until it is locked in place. (Fig.C)
Air outlet connector
adaptor A
or
Fig.C
Install the Window Slider Kit
Foam Seal A
window sash
Horizontal Vertical
1.Cut the foam seal(adhesive type) to the proper length and attach it to the window sash.
2.Attach the window slider kit to the window sash. Adjust the length of the Window Slider
Kit: Loose the screw A to adjust the length of the Window Slider Kit, then tight the screw
when the length is suitable.
Note: the length of the Window Slider Kit is 67.5cm to 120cm.
window
slider
kit
Screw A