Instructions / Assembly

Don’t apply the cold air to the body for a long time. It will
deteriorate your physical conditions and cause health problems.
Don't block air inlet or air outlet, otherwise, the cooling capacity
will be weakened, even cause system stop operating.
Close the windows and doors, otherwise, the cooling capacity will
be weakened.
If the air filter is very dirty, the cooling capacity will be weakened.
Please clean the air filter regularly.
CAUTION
3
Notices for R410A models
Safety Precautions
WARNING
！
Failure to follow the below precaution could result in electrical
shock, fire or personal injury.
1.The plug must be plugged into an outlet that is properly
installed and grounded.
2. Do not use an extension cord or plug adaptor with this unit.
Installation
* If the unit you bought has the pump drain outlet, as shown below, please drain
in this way :
Remove the pump drain plug from the back of the unit, attach the drain hose
to the hole. Place the other end of the hose in the drainage way or other drain
areas.
Note:
drain, making sure that there are no kinks that will stop the water flowing. Place the
end of the hose into the drain and make sure the end of the hose is down to let the
water flow smoothly. Do never let it up.
Make sure the hose is secure and there are no leaks. Direct the hose toward the
Pump
drain outlet
When the water level of the bottom tray reaches predetermined level, the digital display
area shows "P1"and the WATER FULL indicator light illuminates.
Carefully move the unit to a drain location, remove
the bottom drain plug and let the water drain away.
Reinstall the bottom drain plug and restart the
machine until the P1 symbol disappears. If the error
repeats, call for service.
Drain outlet
NOTE: Be sure to reinstall the bottom drain
plug before using the unit.
*
14