Instructions / Assembly

Safety Precautions
1
Incorrect installation or operation by not following these instructions
may cause harm or damage to people, properties, etc.
The seriousness is classified by the following indications:
CAUTION
This symbol indicates the
possibility of injury or
damage to properties.
This symbol indicates
the possibility of death
or serious injury.
WARNING
！
！
WARNING
！
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
(Only for the AC with CE-MARKING)
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
(Except for the AC with CE-MARKING and UL )
The air conditioner must be grounded. Incomplete grounding
may result in electric shocks.
！
！
！
！
This unit is designed for indoor use only.
！
The unit must be placed on the horizontal ground to prevent
tilting and sliding.
Causes
Solutions
The Wind Blowing Out, But The Cooling Effect Is Bad
Causes
Solutions
Noise or vibration
●The ground is not level or not flat enough. ■ Place the unit on a flat, level ground
if possible.
Causes
Solutions
Causes
Solutions
Unit Doesn't Start When Pressing ON/OFF Button
Air Condition Will Not Operate
To save of a service call, please try the suggestions below to see if you can
solve your problem without outside help.
the cost
● The power switch is released.
● Power supply failure.
● The fuse is burnt.
● It doesn't reach the setting time for
starting up.
■ Switch on the power.
■ Wait for the recovery of power supply.
■ Replace the fuse .
■ Wait or eliminate the original setting.
by professional
● It is not four minutes after switch off.
● Room temperature is lower than the
setting temperature under cooling mode
or higher than setting temperature under
heating mode.
■ Wait four minutes.
■ Reset the setting temperature.
● Mistakes in temperature setting.
● The air filter is blocked by dust.
● The air inlet or outlet of machine is
blocked.
● Turn the air conditioner on in very
hot room.
● Cooling capacity is insufficient.
● The doors or windows are open.
■ Set a proper temperature, setting
temperature should be lower than
ambient temperature.
■ Clean the air filter.
■ Remove the obstruction.
■ Allow additional time to remove stored
heat from walls ,ceiling, floor and furniture.
■ Reconfirm the required cooling
capacity with your dealer.
■ Close the doors and windows.
Troubleshooting
16