Instructions / Assembly

Operation
Fan operation mode
1. Press MODE button in a sequence until the fan indicator is lighted.
2. Press the FAN button to select the fan speed.
Drying operation mode
1. Press the MODE button in a sequence until the dry indicator is lighted.
2. The fan will run at a fixed speed at this operation mode.
3. Close windows and doors for the best dehumidifying effect.
Before starting the unit
1. Select a suitable location, make sure the unit is near to an electrical outlet.
2. Install the flexible exhaust hose and the adjustable window slider kit.
3. Plug the unit into a right outlet.
Cooling operation mode
1. Press the MODE button in a sequence until the cool indicator is lighted.
2. Press the " "and " "button to set your desired setting temperature.
3. Press FAN button to select the fan speed.
+ -
Heating operation mode (Cold wind type has no heating function)
1. Press the MODE button in a sequence until the heat indicator is lighted.
2. Press the "+"and "- button to setting your desired setting temperature.
3. Press FAN button to select the fan speed.
"
Failure to follow the below precaution could result in electrical shock, fire or
personal injury.
1. The plug must be plugged into an outlet that is properly installed and
grounded.
2. Do not use an extension cord or plug adaptor with this unit.
WARNING
Note: The setting temperature can not be adjusted.
Note: The setting temperature and fan speed can not be adjusted.The setting temperature
is 25℃(77°F) and the fan speed is low.
8
Auto-restart function:
If power to the unit is interrupted, the unit will restart itself in its last used mode /
settings once power is restored. The compressor will restart after 4 minutes.
1.Set: Press the sleep button 10 times within 5 seconds, buzzer sounds 4 times.
2.Cancel: Press the sleep button 10 times within 5 seconds, buzzer sounds 2 times.
Parts
Parts name
Quantity
Remote controller
and Battery
1set
1pc
NOTE:
All the illustrations in this manual are for explanation purpose only. Your air conditioner
may be slightly different. the actual shape shall prevail.
Drain hose
Optional parts ( .NOTE: # ), some models without
1pc
mobile air-conditioner air louver notes:
Adaptor A,
Adaptor B(flat mouth) ,
Window Slider Kit
Exhaust duct ,
Accessories
9
SET TEMPERATUR(℃)
SET
ON/OFF
MODE
CLEA N SPEED
SLEE P
LOCK
HEATER
SWING DUST SWING 2
HEALTH
FUNGUSPROOF
SCREEN TIMER
AUTO FAN
COOL HIGH
DRY MID
HEAT LOW
2pc
1pc
Type A Screws(#)
Security bracket(#)
4pc
Type B Screws(#)
Adaptor B(round mouth)(#) ,
Wall exhaust Adaptor(#)
1set
2pc
1pc
Type A foam seal(adhesive)(#)
Type B foam seal(non-adhesive)(#)
1/2" screws
3/4" screws
2pc