User Manual

7
Power pad
Press to turn the dehumidifier on and off.
Humidity set control pad(down and up)
The humidity level can be set within a range of 35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.For drier air, press the pad and set to a lower percent value(%).
For damper air, press the pad and set a higher percent value(%).
Timer pads
Press to initiate the Auto start and Auto stop feature, in conjuction with the and key pads
Auto Defrost
When frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue
to run until the frost disappears. run until the frost disappears.
Pump pad
Press to activate the pump operation.
Note: Make sure the pump drain hose is installed into the unit and the continuous drain hose is removed
from the unit before the pump operation is activated. When the bucket is full, the pump starts to work.
Refer to the next pages for removing the collected water. Do not use this operation when the outdoor
temperature is equal to or less than 32℉(0℃)
Display
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting, then
shows the actual (±5% accuracy) room % humidity level in a range of 30% RH (Relative Humidity) to
90%RH(Relative Humidity). Error Codes and Protection Codes:
AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats, call for service.
ES- Temperature sensor error-- Unplug the unit and plug it back in. If error repeats, call for service.
P2- Bucket is full -- Empty the bucket.
Eb- Bucket is removed or not in right position -- Replace the bucket in the right position.(for some
models with models)
EC- Unit malfuction--Please make sure whether the enviroment temperature is suitable for the stated
temperature in the manual or not.If not,please operate the unit under the stated temperature.If the
enviroment temperature is suitable for the stated temperature,please call for service.