Use and Care Manual

4
CONTROL PADS ON THE DEHUMIDIFIER
Control pads
3
When you push the button to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
NOTE: The control panel of the unit you purchased may be slightly different according to the
models.
TURBO PAD
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High
for maximum moisture removal. When the humidity
has been reduced and quiet operation is preferred,
set the fan control to Normal.
2
Filter Pad
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter l ight) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter pad and the light will go off.
4
Timer Pad
Press to initiate the Auto start and Auto stop feature,
in conjuction with the and key pads.
6
7
Power Pad
Press to turn the dehumidifier on and off.
5
Humidity Set Control Pads
: Up/Down Pads
TIMER Set Control Pads
Use the Up/Down pads to set the Auto
start and Auto stop time from 0.0 to 24.
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the pad and set to a lower
percent value(%).
For damper air, press the pad and set a higher
percent value(%).
1
Continue Pad
Press to activate the continuous dehumidifying
operation.
Fig.1
High fan
indicator light
On
Off
Full
Clean filter
indicator light
Continuous
operation on
indicator light
Timer on/off
indicator light
Auto defrost
Auto defrost operation
on indicator light
Bucket full
indicator light
1 2 3 4 5 6
7
Display
Shows the set % humidity level from 35% to 85% or auto
start/stop time (0~24) while setting, then shows the actual
( 5% accuracy) room % humidity level in a range of 30%
RH(Relative Humidity) to 90%RH(Relative Humidity).
Error Codes and Protection Code:
AS- Humidity sensor error--Unplug the unit and plug it back
in. If error repeats, call for service.
ES- Temperature sensor error-- Unplug the unit and plug it
back in. If error repeats, call for service.
P2- Bucket is full or bucket is not in right position-- Empty
the bucket and replace it in the right position.
E1- Unit malfunction-- Unplug the unit and plug it back in.
If error repeats, call for service.