User Guide

STAGE 3
Checking Ethernet
Connection
SYSTEM 2 and SYSTEM 3 (both red) start flashing while the server looks for an
Ethernet signal (aka a physical Ethernet connection). SYSTEM 2 and 3 will flash
forever until the server finds this signal.
SYSTEM 2 and SYSTEM 3 (both red) flash while the server tries to obtain an IP
address. Once the server obtains its IP address, the server is completed booted up and
running. The status lights will now have a new meaning. Please refer to the USB
SERVER Is Running (Has Finished Booting Up) table.
Tech Note : If the server is configured to use a Static IP address, the second stage is
completed immediately. For DHCP only, it waits for the DHCP server. For Zeroconfig
only, it takes about 1-2 seconds while it negotiates. For Default, it waits for DHCP for 10
seconds before taking a Zeroconfig address (1-2 seconds).
STAGE 4
Checking Ethernet
Connection
The ( green) USB 1-4 lights are turned ON as the firmware starts running.
STAGE 2
Firmware Loading
STAGE 1
Server Is Booting Up
Stage
When the USB server is first powered on, the (red) SYSTEM 3 light is ON while the server
is booting.
TROUBLESHOOTING : If this light never goes off or the 4 (green) USB lights never
come on, you may have a serious hardware failure. Please contact Keyspan tech
support immediately.
USB SERVER Is Booting Up
Status
Now that your USB Server is running, please refer to the following table for detailed description
of the server's status lights:
Keyspan:USB Server - User Manual
This User Manual applies to the Keyspan USB Server Software Version 1.0
Rev 2004apr06 Page 37