User Guide

2 Installation Instructions
Installing the USB Server Hardware
Note: Do not connect your USB devices (ie printers, scanners,
etc.) to the Keyspan USB Server until you have finished
installing the USB Server software and hardware!!! The next
section, Using Your USB Devices Over Your Network , will walk you
through the process of connecting and using your USB devices with the
Keyspan USB Server.
Step 1 - Connect Keyspan USB Server To Your Network
First connect an Ethernet cable to the USB Server's Ethernet port (see next image):
Once the Ethernet cable is connected, connect the other end of the cable to your network. This can
be a free Ethernet port on your DSL router, Ethernet hub, or 802.11 (aka Airport) router/base
station.
If you do not have a network, you can connect the USB Server directly to the Ethernet port on
your computer.
Tech Note: If you have more questions about connecting the USB Server to your
network, please read the USB Server Networking Discussion section in this
manual.
Step 2 - Connect the USB Server's Power Supply / Read the LEDs
Connect the included power supply to the USB Server's power connector (see next image):
Keyspan:USB Server - User Manual
This User Manual applies to the Keyspan USB Server Software Version 1.0
Rev 2004apr06 Page 3