User Guide

Using your paper clip, quickly press the reset button inside the hole. This will reset/reboot your
server.
Reboot Server Into 'Safe Mode' Using The Reset Button
If you've made an unwanted change to the USB Server settings and can't access your server
anymore, you can boot your server into a 'safe mode'. In this mode, your server will reboot using
default settings (ie Multi-user connect mode, default IP mode) and allow you to view and edit your
server's settings. If you want to return to your settings, just power cycle your server.
To boot into 'safe mode', press and hold the reset button until the lights turn off (this will take 3+
seconds).
The USB Server is now resetting itself. It will take approximately 15 seconds to complete the
reset. In the Keyspan USB Server application, make sure that your Local UDP Port is set to 3842.
Once you've verified the port, check the the Keyspan USB Server application to see if your server
appears. If it does not appear, please contact Keyspan technical support for further assistance.
When You Need More Help...
The Keyspan web site, http://www.keyspan.com/ is your best source for technical support
information. The web site includes technical notes, reference manual updates, and answers to
frequently asked questions.
You may also contact our technical support department directly via email, phone, or fax. Please
see the Support Information section in this manual for more details.
Keyspan:USB Server - User Manual
This User Manual applies to the Keyspan USB Server Software Version 1.0
Rev 2004apr06 Page 28