User Guide

Once you Apply Changes , the USB Server (hardware) will disconnect any users connected to it
and restart itself. Please note that your USB Server will disappear temporarily from the Keyspan
USB Server application while it is restarting.
If you do not want to keep the changes that you made, cancel your changes by clicking the Cancel
button. Your USB Server hardware will not be restarted.
Restoring Default Settings
You can reset USB Server to factory settings by using the Keyspan USB Server application. To
do this, select and edit your USB Server (as detailed earlier in this section) and then click the
Restore Defaults button (see next image).
Restoring the default settings will cause the USB Server (hardware) to restart.
Tech Note : Restoring to default settings will also set the USB Server's UDP port to
3842. If you previously changed your UDP port, remember to change the Keyspan
USB Server application's Local UDP Port to 3842. You may not be able to see your
USB server if you fail to change your Local UDP Port. To change the Local UDP Port,
select Local UDP Port in the Keyspan USB Server application's Config menu.
IMPORTANT NOTE FOR FIREWALL USERS : If you've configured your firewall
to allow access to the USB Server, remember to check your firewall's setting. The USB
Server's IP address may have changed after restoring to default settings.
Keyspan:USB Server - User Manual
This User Manual applies to the Keyspan USB Server Software Version 1.0
Rev 2004apr06 Page 17