Technical data

- 11 -

2.3 Installation of the keyboard

Recommended requirement for that is the successful installation of the USB receiver under point 2.2.

• If you haven’t done yet, remove the covering of

the battery case on the bottom of your keyboard.

Install the included batteries of type AAA 1.5 V

considering the right polarity in the battery case

(see picture).

• Switch the I/O sliding switch to ON position!

Advice:

The USB receiver and the keyboard are factory-made already synchronised on the same channel.

Normally you have not to make a new-synchronisation (as described under point 2.4). The keyboard is

immediately functioning.

• Now you can check the functionality by pressing any

key of your keyboard. If you press the Windows key,

there has to open for instance the Windows Pop-up

menu down left on your screen. If so, your wireless

keyboard is working correctly now. If not, please

synchronise the USB receiver and the keyboard again

like described under point 2.4.

Advise:

Should the functionality be influenced by other users applying their wireless keyboard close-by, make a

new-synchronisation as described under point 2.4.