Datasheet

08 | Keysight | DSOXT3NFC/DSOX4NFC Automated NFC Test Software, N2116A/N2134A/N2135A Programmable NFC 3-in-1 Antenna - Data Sheet
Table 4. 33512B waveform generator (transmitter)
Parameter Output channel Value
Output impedance Load modulation (channel-1) 50-Ω
RF carrier (channel-2) 50-Ω
Output voltage range RF carrier, Load modulation 1 mVpp to 10 Vpp (re: 50-Ω)
Output power RF carrier > 23.9 dBm
Output voltage accuracy RF carrier, Load modulation ± 3.5% of setting ± 1 mVpp at 13.56 MHz
Output voltage resolution Load modulation 16 bits (160 µV at 10 Vpp)
RF carrier 4 digits (1 mV or 0.01 dBm at 10 Vpp)
Frequency range RF carrier (channel-2) 1 µHz to 20 MHz
1
Frequency accuracy RF carrier, Load modulation ± 2 ppm of setting ± 15 pHz (< 27 Hz at 13.56 MHz)
Frequency resolution RF carrier 1 µHz
Spurious RF carrier Standard: < –75 dBc, increasing +20 dBC/decade
above 2 MHz
Option OCX: < –75 dBc, increasing +20 dBc/decade
above 10 MHz
1. Maximum frequency based on the 20 MHz 33512B. Higher frequency ranges available on higher frequency 33500 and 33600 models.
Technical Performance Characteristics (Continued)
Table 5. N2116A/N2134A/N2135A 3-in-1 antenna
Resonant frequency 13.56 MHz
Poller coil size Poller 3 equivalent
Listener coil size Listener 3 equivalent
Listener loads (congurable) 82, 330, 820, 5000-Ω
Standards supported NFC Forum Types A, B, F
Poller/Listener test spacing
– N2116A 5 mm
– N2134A 10 mm
– N2135A 15 mm
I/O ports
Tx – RF input port for Poll mode and Resonant Frequency Connector type: SMA
– Impedance 50-Ω
– Input power range –1.85 to +24.25 dBm
– Frequency range 10 to 20 MHz
Rx – RF output port for Poll mode and Resonant Frequency Connector type: SMA
– Impedance 50-Ω
– Output voltage range 10 mV to 1 V
LM (load modulation) for Listen mode Connector type: SMA
– Impedance > 10 MΩ
– Input voltage range 0 to 5 V
Sense – RF output for Listen mode Connector type: SMA
VR – VDC output for Listen mode Connector type: SMA
– Range 0 to 10 VDC
Communication and power Connector type: MicroUSB