Datasheet

Acquisition modes

Normal

Peak detect Capture glitch as narrow as 500 ps at all timebase settings.

Averaging Select from 2,4,8,16, 64... to 65,536

High resolution mode 12 bits of resolution when ≥ 20 µs/div

Segmented Re-arm time= 19 µs (minimum time between trigger events)

Trigger system

Trigger modes • Edge (rising/falling alternate, either)–Conventional level-driven trigger.

• Pulse width (or glitch)–Trigger on a pulse width less than, greater than, or

within a time range, with a selectable time limit ranging from 17ns to 10 s.

• Pattern-trigger on a logical AND combination of the channels. Each

channel can have a value of zero, one, don’t care (X), or a rising or falling

edge (one channel only).

• Video–Trigger on all lines or individual lines, odd/even or all fields from

composite video or broadcast standards (NTSC, PAL, PAL-M, SECAM).

Trigger coupling Coupling selections: AC, DC, noise reject, LF reject and HF reject.

Trigger source Each analog channel, each digital channel (MSO models or DSOX2MSO

upgrade, Ext, WaveGen, line)

Trigger sensitivity (internal)* < 10 mV/div: greater of 1 div or 5 mV; ≥ 10 mV/div: 0.6 div

Trigger sensitivity (external)* 200 mV (DC to 100 MHz); 350 mV (100 MHz - 200 MHz)

Cursors

Types Amplitude, time , frequency (FFT), manual, tracking, binary, HEX

Measurements ∆T, 1/∆T, ∆V/X, 1/∆X, ∆Y, Phase and Ratio

Cursors** • Single cursor accuracy:

±[DC vertical gain accuracy + DC vertical offset accuracy + 0.25% full scale]

• Dual cursor accuracy:

±[DC vertical gain accuracy + 0.5% full scale]*

Automatic waveforms measurements

Voltage Snapshot all, maximum, minimum, peak-to-peak, top, base, amplitude, overshoot, preshoot, average- N

cycles, average-full screen, DC RMS- N cycles, DC RMS- full screen, AC RMS- N cycles

Time Period, frequency, rise time, fall time, + width, – width, duty cycle, delay A→B (rising edge), delay A→B

(falling edge), phase A→B (rising edge,) and phase A→B (falling edge)

Oscilloscopes redefined: Breakthrough technology delivers more scope for the same budget

Performance characterisitics

* Denotes warranted specifications, all others are typical.

Specifications are valid after a 30-minute warm-up period and from ±10 °C firmware calibration temperature.

** 1 mV/div and 2 mV/div is a magnification of 4 mV/div setting. For vertical accuracy calculations, use full scale of 32 mV for

2 mV/div sensitivity setting.