Datasheet

Page 15
Find us at www.keysight.com
Performance Characteristics
Specification overview
2002A 2004A 2012A 2014A 2022A 2024A
Bandwidth
1
(–3 dB) 70 MHz 100 MHz 200 MHz
Calculated rise time (10 to 90%) ≤ 5 ns ≤ 3.5 ns ≤ 1.75 ns
Input channels DSOX 2 4 2 4 2 4
MSOX
2 + 8 4 + 8
2 + 8
4 + 8 2 + 8
4 + 8
Maximum sample rate
1
2 GSa/s half-channel interleaved, 1 GSa/s per channel
Maximum memory depth 1 Mpt per channel (standard)
Display size and type 8.5-inch WVGA with 64 levels of intensity grading
Waveform update rate 200,000 waveforms per second
Vertical system analog channels
Input coupling AC, DC
Input sensitivity range 1 mV/div to 5 V/div
2
Input impedance 1 MΩ ± 2% (11 pF)
Vertical resolution 8 bits (measurement resolution is 12 bits with averaging)
Dynamic range
± 8 divisions from center screen
Maximum input voltage 135 Vrms; 190 Vpk
Probing technology allows testing of higher voltages. For example, the included N2841A or
N2842A 10:1 probe supports testing up to 300 Vrms
Use this instrument only for measurements within its specified measurement category (not rated
for CAT II, III, IV). No transient overvoltage allowed
DC vertical accuracy ± [DC vertical gain accuracy + DC vertical offset accuracy + 0.25% full scale]
2
DC vertical gain accuracy
1
± 3% full scale (≥ 10 mV/div); ± 4% full scale (< 10 mV/div)
2
DC vertical offset accuracy ± 0.1 div ± 2mV ± 1% of offset setting
Channel-to-channel isolation ≥ 40 dB from DC to maximum specified bandwidth of each model
Position/offset range 1 MΩ 1 mV to 200 mV/div: ± 2 V, > 200 mV to 5 V/div: ± 50 V
Hardware bandwidth limits Approximately 20 MHz (selectable)
Horizontal system analog channels
2002A 2004A 2012A 2014A 2022A 2024A
Time base range 5 ns/div to 50 s/div 2 ns/div to 50 s/div
Time base accuracy
1
25 ppm ± 5 ppm per year (aging)
Time base delay time range Pre-trigger Greater of 1 screen width or 200 μs (400 μs in interleaving mode)
Post-trigger 1 s to 500 s
Channel-to-channel deskew range ± 100 ns
Δ Time accuracy (using cursors) ± (time base accuracy
1
reading) ± (0.0016
1
screen width) ± 100 ps
1. Denotes warranted specifications, all others are typical. Specifications are valid after a 30-minute warm-up period and from ± 10 °C firmware calibration
temperature.
2. 1 mV/div and 2 mV/div is a magnification of 4 mV/div setting. For vertical accuracy calculations, use full scale of 32 mV for 1 mV/div and 2 mV/div sensitivity
setting.
Step 4. Add the final touches
Recommended accessories 2000 X-Series
LAN/VGA connection module DSOXLAN
GPIB connection module DSOXGPIB
Rack mount kit N6456A
Soft carrying case and front panel cover N6457A
Hard copy manual N6458A
Front panel cover (only) N2747A
ANSI Z540-1-1994 Calibration MSOX or DSOX2000-A6J
BenchVue Oscilloscope application BV0004B
User-defined Application (UDA) software N5467B/C