User Manual

Keysight InfiniiVision 1000 X-Series Oscilloscopes Programmer's Guide 5
• Chapter 26, “:TIMebase Commands,” starting on page 559, describes
commands that control all horizontal sweep functions.
• Chapter 27, “:TRIGger Commands,” starting on page 571, describes commands
that control the trigger modes and parameters for each trigger type.
• Chapter 28, “:WAVeform Commands,” starting on page 619, describes
commands that provide access to waveform data.
• Chapter 29, “:WGEN Commands,” starting on page 655, describes commands
that control waveform generator (Option WGN) functions and parameters.
• Chapter 30, “:WMEMory<r> Commands,” starting on page 687, describes
commands that control reference waveforms.
• Chapter 31, “Obsolete and Discontinued Commands,” starting on page 697,
describes obsolete commands which still work but have been replaced by
newer commands and discontinued commands which are no longer supported.
• Chapter 32, “Error Messages,” starting on page 743, lists the instrument error
messages that can occur while programming the oscilloscope.
The command descriptions in this reference show upper and lowercase characters.
For example, :AUToscale indicates that the entire command name is :AUTOSCALE.
The short form, :AUT, is also accepted by the oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
• Chapter 33, “Status Reporting,” starting on page 751, describes the
oscilloscope's status registers and how to check the status of the instrument.
• Chapter 34, “Synchronizing Acquisitions,” starting on page 771, describes how
to wait for acquisitions to complete before querying measurement results or
performing other operations with the captured data.
• Chapter 35, “More About Oscilloscope Commands,” starting on page 781,
contains additional information about oscilloscope programming commands.
Finally, there is a chapter that contains programming examples:
• Chapter 36, “Programming Examples,” starting on page 791.
See Also • For more information on using the SICL, VISA, and VISA COM libraries in
general, see the documentation that comes with the Keysight IO Libraries
Suite.
• For information on controller PC interface configuration, see the
documentation for the interface card used (for example, the Keysight 82350A
GPIB interface).
• For information on oscilloscope front-panel operation, see the User's Guide.
• For detailed connectivity information, refer to the Keysight Technologies
USB/LAN/GPIB Connectivity Guide. For a printable electronic copy of the
Connectivity Guide, direct your Web browser to www.keysight.com and search
for "Connectivity Guide".