User Manual

271
Keysight InfiniiVision 1000 X-Series Oscilloscopes
Programmer's Guide
16 :FRANalysis Commands
Control oscilloscope functions associated with the Frequency Response Analysis
(FRA) feature, which is available in G-suffix oscilloscope models (that have a
built-in waveform generator). See "Introduction to :FRANalysis Commands" on
page 272.
Table 59 :FFT Commands Summary
Command Query Options and Query Returns
n/a :FRANalysis:DATA?
(see page 273)
<binary_block> ::=
comma-separated data with
newlines at the end of each row
:FRANalysis:ENABle
{{0 | OFF} | {1 |
ON}} (see page 274)
:FRANalysis:ENABle?
(see page 274)
{0 | 1}
:FRANalysis:FREQuency
:MODE <setting> (see
page 275)
:FRANalysis:FREQuency
:MODE? (see page 275)
<setting> ::= {SWEep | SINGle}
:FRANalysis:FREQuency
:SINGle
<value>[suffix] (see
page 276)
:FRANalysis:FREQuency
:SINGle? (see
page 276)
<value> ::= {20 | 100 | 1000 |
10000 | 100000 | 1000000 |
10000000 | 2000000}
[suffix] ::= {Hz | kHz| MHz}
:FRANalysis:FREQuency
:STARt
<value>[suffix] (see
page 277)
:FRANalysis:FREQuency
:STARt? (see page 277)
<value> ::= {10 | 100 | 1000 |
10000 | 100000 | 1000000 |
10000000}
[suffix] ::= {Hz | kHz| MHz}
:FRANalysis:FREQuency
:STOP <value>[suffix]
(see page 278)
:FRANalysis:FREQuency
:STOP? (see page 278)
<value> ::= {100 | 1000 | 10000 |
100000 | 1000000 | 10000000 |
20000000}
[suffix] ::= {Hz | kHz| MHz}
:FRANalysis:PPDecade
<value> (see page 279)
:FRANalysis:PPDecade?
(see page 279)
<value> ::= {10 | 20 | 30 | 40 |
50}
:FRANalysis:RUN (see
page 280)
n/a n/a