Datasheet

Adapters for Resistance Measurement
Short description Model Additional information
GPIO-BNC Trigger Adapter N1294A-031
Digital I/O Trigger Cable for Multiple Unit
Control
N1294A-032 Required to use the multiple units of the
B2901A/02A/11A/12A with EasyEXPERT group+ software
High Resistance Meter Fixture Adapter N1413A Adapter to enable to use the 16008B, 16117B/C and 16339A with the B2985A/87A
for resistance measurement
High Resistance Measurement
Universal Adapter
N1414A For resistance measurement using the B2985A/87A
N1413A High Resistance Meter Fixture Adapter
for B2985/87A:
This adapter enables to use the 16008B,
16117B/C and 16339A with the
B2985A/87A.
In addition, by using this adapter, sourced
voltage can be monitored by the Voltmeter
in the B2985A/87A without changing
connection.
Terminal Connector
N1414A High Resistance Measurement
Universal Adapter for B2985/87A:
This adapter simplifies the cabling when
making resistance measurement with the
B2985A/87A.
In addition, by using this adapter,
sourced voltage can be monitored by the
Voltmeter in the B2985A/87A without
changing connection.
Terminal Connector
Input
Interlock Control Switch
Output/Ground
Input
Control Switch
Output/Ground
Input: Triaxial (special screw-type)
Output/Ground *: High Voltage BNC
(special type) Interlock: 6 pin mini plug
interlock connector
Note: please refer to User’s Guide for
Keysight B2980A series for the details.
http://literature.cdn.keysight.com/
litweb/pdf/B2980-90010.pdf
Input: Triaxial
Output/Ground *: Banana connector
Note: please refer to User’s Guide for
Keysight B2980A Series Femto/Picoam-
meter & Electrometer for the details.
http://literature.cdn.keysight.com/
litweb/pdf/B2980-90010.pdf
N1294A-031 GPIO - BNC Trigger Adapter:
This adapter is used to route the triggering
signals from the instrument’s GPIO Dsub25
connector for two coax connectors. It is
available for the B2901A/02A/11A/12A and
the B2961A/62A.
In addition, you can access any of the
Digital I/O signal pins by soldering a wire to
the corresponding Digital I/O path located
on the adapter’s internal printed circuit
board.
Note: This requires opening the
N1294A-031.
N1294A-032 Digital I/O Trigger Cable for
Multiple Unit Control
This adapter is required to use the
multiple units of the B2901A/02A/
11A/12A with EasyEXPERT group+
software. The adapter has 4 Dsub25
connectors, which enables you to
connect up to 4 units of the B2901A/
02A/11A/12A and to control them
through EasyEXPERT group+software.
04 | Keysight | Accessories for the B2900 Precision Instrument Family - Catalog