Datasheet

29
1
Side by side modules of equal depth require a Lock Link Kit (5061-9694)
2
1/4 MW can be center mounted using two of these kits
What you get in the box
1 Standard flange
1 Adapter flange
Attaching screws
Front-panel rackmounting
screws
Ordering Information
Instrument Module Mounts 1/4 Mounts 1/2 MW or Mounts 3/4 MW
Height MW Modules 2 each 1/4 (3 each 1/4 MW
2
or 1/4
MW
1
Modules & 1/2 MW side by side)
88.1 mm (3.5 in) 5063-9239 5063-9240 (34190A) 5063-9241
132.6 mm (5.25 in) - 5063-9243 (34193A) -
177.0 mm (7.0 in) - 5063-9245 -
Kit includes 1 rack flange +
3
/
4
MW 1 rack flange +
1
/
2
MW 1 rack flange +
1
/
4
MW
extension adapter flange extension adapter flange extension adapter flange
+ screws + screws + screws
A B C
Rackmount Adapter Kits
Rackmount adapter kits are available to
mount an instrument, or combination of
instruments, that is less than one full
module width (MW).
• Individual 1/4 MW or 1/2 MW
modules use the kits shown in the
table below.
• Combinations of 1/4 MW or 1/2 MW
(of equal depth) are first joined side-by-
side with the Lock Link Kit (see page 32
for PN 5061-9694). Combinations joined
side-by-side must be the same depth
and height. Then the rackmount adapter
kit is applied. If modules are of unequal
depth or height, a support shelf (as
shown on page 31) can be used.
• For combinations of instruments adding
to 1 MW, use the rackmount flange kit
(see Selecting a Rackmount Flange or
Handle Kit, page 27).
• Hole patterns conform to EIA and
IEC standards.
Rackmount adapter kit with mounting hardware
(5063-9239)
Rackmount adapter kits for 88.1 mm instrument
module height (5063-9239, 5063-9240 (34190A),
5063-9241)
Rackmount adapter kits for 1/2 MW
(5063-9240 (34190A), 5063-9243 (34193A),
5063-9245)
Instrument
Rackmount Kits
Rackmount Kits
A
A
B
B
A
C
C
►