User manual
Calibration 2
U2300A Series DAQ Service Guide 27
3 Connect the DAQ device to the PC with mini- B type USB
cable. The connected DAQ device will be visible in the
Instrument I/O on this PC panel as illustrated in Figure 2- 5.
4 Select the DAQ device that you wish to send the SCPI
commands to and then click the Interactive IO icon on the
toolbar to launch the Agilent Interactive IO. See Figure
2- 5.
Figure 2-9 Launch the Interactive IO in Agilent Connection Expert
5 The Agilent Interactive IO dialog box will appear as shown in
Figure 2- 6. Click Send & Read to send the “*IDN?” default
command. This instrument’s response should appear in
the Instrument Session History panel.
Step 1:
Step 2: Click the Interactive IO icon
Select the instrument