Manualshelf

User manual

ManualsBrandsKEYSIGHT TECHNOLOGIES ManualsTest & MeasurementCurrent clamp, Handheld multimeter digital CAT III 600 V, CAT IV 300 V Display (counts):
11121314151617181920
1 Introduction
Preparing Your Clamp Meter
4 U1190A Series User’s Guide
1 Open the battery cover. Loosen the screw with a suitable
Phillips screwdriver and remove the battery cover as
shown in Figure 1- 1.
2 Insert the batteries. Observe the proper battery polarity.
The terminal ends of each battery are indicated inside the
battery compartment.
3 Close the battery cover. Place the battery cover back in
its original position and tighten the screw.
Figure 1-1 Installing the batteries
The battery level indicator in the lower left- hand corner of
the display indicates the relative condition of the batteries.
Table 1- 1 describes the various battery levels the indicator
represents.
U119XA UG.book Page 4 Thursday, September 15, 2011 4:03 PM