User manual

Chapter 3 Front-Panel Operation

Remote Voltage Sensing at the Front and Rear Terminals

Stability

Remote Voltage Sensing Connections

⊥

Note When you make the remote voltage sensing connections at the front or rear panel

terminals, make sure to disconnect all the connections to the load and sense leads

at the other end terminals. Do not make the sensing connections at both front and

rear terminals at the same time. It will cause to damage the power supply seriously.

Note During remote sensing setup, it is strongly recommended to power off (by presssing

power ON/OFF button) the power supply to avoid undesirable damage to the load

or the power supply.