User manual

Chapter 4 Remote Interface Reference
Output Setting and Operation Commands
4
INSTrument:COUPle[:TRIGger] {ALL | NONE |< >}
TRIGger
TRIGger
*RST
TRACk
INST:COUP INSTrument:
COUPle
VOLTage:TRIGgered
CURRent:TRIGgered
"INST:SEL P6V"
"VOLT:TRIG 5"
"CURR:TRIG 3"
"INST:SEL P25V"
"VOLT:TRIG 20"
"CURR:TRIG 0.5"
"INST:COUP P6V,P25V"
"TRIG:SOUR IMM"
"INIT"
Note If you select the bus trigger source in the above program (see page 79 for
the detailed information), you must send the *TRG or Group Execute
Trigger (GET) command to start the trigger action after sending the
INITiate command.
Example (1)