User's Manual
II. Hardware
Hardware Installation …………………………. 2
Hardware Removal ……………………………. 3
III.
Software
Software Installation …………………………… 3
Automatic Installation ………………………….. 3
Password Setting ………………………………. 4
Product ID Recognition ………………………… 5
Software Removal …………………………….... 6
IV. User Guide ……………………………………….. 7
V.
Frequently Asked Questions ………………….. 10
VI. Technical Support and Service …………………
Model :
Wireless PC Lock
Accessories
:
1. Transmitter unit
×
1 / Receiver unit
×
1
2. 3V (CR2032) Battery
×
1
3. Driver CD
×
1
Function
:
1.
The computer automatically enters
“
Lock Mode
”
when the user is away from computer
by more than 2 meters
2.
The computer automatically resumes normal operation when the user is back to within
2 meters range
3. Once the computer enters the
“
Lock Mode
”
a password is required to use the computer
if the transmitter/receiver pair is not available to unlock the computer
4.
One transmitter can be shared with several computers
5. The computer will signal
“
Warning
”
when battery voltage of the transmitter is too low
Specifications
:
1.
One unique
“
Security Code
”
in the Transmitter
Computer automatically recognizes the code itself
2.
A maximum of 5 sets of
“
Password
”
and each set allows maximum of
125 numbers/characters (case insensitive)
3.
Operation frequencies: □ FCC/315MHz;□ CE/434MHz
4. Transmitter Power Supply: DC 3V
5. Battery Usage: approximately 2000 hours
6. Receiver Power Supply: DC 5V, provided by the computer through USB port
7.
Software Driver: support Windows 98 SE / ME / 2000 / XP
Hardware Installation
A.
Insert the Wireless PC Lock receiver into the USB port and the computer will automatically
detect and determine if the hardware is properly installed.
B.
If computer fails to detect the receiver device after the hardware installation, the following
window will display on the screen. Click the
“ Exit “
button and repeat the above step again.
第 2 頁,共 10 頁Table of Contents
2003/10/30file://C:\tmp\安規\SEND\FOR%20FCC\Eng\ENG.htm