ClicBot Modules - User Guide

Connection Security and Privacy
Connection via hotspot is suitable when Wi-Fi is not available or the signal
is weak.
How to connect to ClicBot App via hotspot:
1. Swipe upwards on the screen of the Brain Module to view the system
menu, then select the Device icon , and click “Hotspot Connection” to
generate a QR code.
2. Open the ClicBot App, select . Click “Connect to Brain” and then select
“Hotspot Connection” to begin scanning.
3. Scan the QR code with your mobile device to set up the connection.
Security Information
This device complies with part 15 of the
FCC Rules. Operation is subject to the
condition that this device does not cause
harmful interference (1) this device may
not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
Any changes or modifications not
expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
NOTE:This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation
If this equipment does cause harmful
interference to radio or television
reception,which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
--Reorient or relocate the receiving
antenna.
--Increase the separation between the
equipment and receiver.
--Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced
radio/TV technician for help.
The device has been evaluated to meet
general RF exposure requirement. The
device can be used in portable exposure
condition without restriction.
FCC ID: 2AWR5-KY002
RSS-Gen Issue 4 December 2014"&"CNR-Gen 4e
Décembre 2014:
--English:
This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2)
This device must accept any interference, including
interference that may cause undesired operation of
the device.
--French:
Le présentappareilestconforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts
de licence. L'exploitationestautorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le
brouillageest susceptible d'encompromettre le
fonctionnement.
IC ID: 26344-KY002
GB19865-2005
、
GB6675.1-2014
、
GB6675.2-2014
、
GB6675.3-2014
、
GB6675.4-2014
The QR Code Generated
by Brain module
Scan the QR code to Set up the Connection
2120