ClicBot Modules - User Guide

Assemble the Modules How to connect modules
All ClicBot modules can be connected to each other by connectors. A
connector contains an A-conn, a B-conn and ‘po-go’ pins. You can connect
two modules by interlacing the A-conn and B-conn, and the golden po-go
pins transfer instruction and supply power.
Note:Align the A-conn of one module with the
B-conn of the other to connect two modules
Modules can be connected at opposite ends & in non-parallel directions.
Parallel Connection Non-Parallel Connection
A-conn
B-conn
Golden po-go pins
1716