User Manual

Connecting to the XG Series
2-9
Preparations
3 Click [Search].
The XG Series connected to the PC appears in the list.
Note
• Clicking [Search] will only display controllers that exist in
the same subnet.
• The controller may not show up initially if there are multiple
controllers on the network. In this case, repeat the search a
few times.
4 Check the box next to the XG Series controller to
register it as a connection and click [OK].
The new connection is added and appears in the
system view.
Connect the XG Series and PC over an Ethernet-based
LAN.
Connecting to the XG Series
Connect the Ethernet cable (commercial straight
cable) to the Ethernet ports on the XG Series
controller and a hub or LAN port device.
Registering the XG Series in XG
VisionTerminal
The XG Series must be registered as a connection so that
the XG VisionTerminal can recognize it.
1 From the [Connections] menu, click [Add Connection].
The [Add Connection] menu appears.
2 Select [Search for Connections/Controllers].
LAN Connection
HUB
(Router)