Owner's manual

5
E SR-750-IM
 Code position adjustment
The SR-750 Series is equipped with the laser pointer to adjust the code position.
Using the laser pointer enables you to adjust the most appropriate code
position easily.
1 Press the TUNE button once on the SR-750 Series to emit the laser
pointer.
The laser pointer emits a laser beam as shown below.
2 The position where the right and left laser beams cross is the center
point of the visual field.
Adjust the center position of the code to this point.
 When using the included mounting bracket
1 Attach the SR-750 Series to the included mounting bracket.
Select the appropriate mounting method from below according to the
application.
2 Fix the mounting bracket to the device.
* Mounting screws (M4) are not included. The thickness of the mounting
bracket, insulating spacer and washer included is approximately 4 mm.
3 Adjust the installation angle of the SR-750 Series.
The adjustment angle for the mounting bracket is ± 10°.
 When not using the included mounting bracket
With this method, you can attach the SR-750 Series to the device without
using the included mounting bracket.
Prepare the following item before mounting the SR-750 Series
• Main unit mounting screw (M4) · · ·Screw hole depth of the SR-750
Series: 4 mm
1 Fix the SR-750 Series at the mounting position with M4 screws.
2 Adjust the installation angle and distance of the SR-750 Series.
Attaching the long distance lens SR-75L4/75L6 will block the laser pointer.
Accordingly, position adjustment using the laser pointer is not possible.
TEST TUNE
SR-625
POW ERR
NET IN
STB
OK/NG/
Focal distance
SR-750HA : 38 mm
SR-750 : 60 mm
SR-751 : 100 mm
SR-752 : 250 mm
NOTICE
TEST TUNE
SR-625
POW ERR
NET IN
STB
OK/NG/
TEST TUN
E
SR-625
POW
ERR
NETIN
STB
OK/
NG/
TEST
TUNE
SR-625
POW
ERR
NETIN
STB
OK/NG/
Mounting bracket
Mounting bracket
Mounting screw(M4)
Tighting torque 0.5N•m
• Be sure to mount the supplied insulation spacer to suppress the
influences of electrical noise from the device.
If the insulation spacer is not mounted, electrical noise may be generated
causing reading error or incorrect reading.
• On the bottom of the mounting bracket, the insulation sheet is attached.
Do not peel off this sheet.
To suppress the influence of electrical noise from the device, provide
insulation for the mounting part of the SR-750 Series and the device.
If insulation is not provided, electrical noise may be generated causing
reading error or incorrect reading.
TEST TUNE
SR-625
POW ERR
NET IN
STB
OK/NG/
Mounting screw (M4)WasherInsulating spacer
NOTICE
TEST TUNE
SR-625
POW ERR
NET IN
STB
OK/NG/
Mounting screw (M4)
Tighting torque 0.5N•m
Mounting screw (M4)
NOTICE