User Manual

Chapter 2 Functions

2-6

English

ENGLISH

3. Refer to the table on page 2-5 and change the mode switches.

4. Close the switch cover, and use a screwdriver to tighten the screws to secure the cover. (The

recommended tightening torque is 0.08 N•m.)

5. Turn on the SL-R11 power, Refer to Chapter 5. Checklist (➮ page 5-1) and check the operation.

CAUTION

• The mode switch settings cannot be changed while the power is on. Be sure to

turn the power off before making changes.

• As shown in the previous table, there are two mode switches provided for each

function. Both mode switches must be on to turn the mode on. (Example: To

enable the start interlock function, mode switches 2 and 6 must be on prior to

supplying power.)

WARNING

• When finished setting the mode switches, be sure to close the switch cover and

tighten the screws.

• Mode switch settings shall only be set by the responsible personnel for using the

system. It must be made so that the machine operators cannot set the mode

switches.