Instruction Manual

Controlling Multi-head Mode
5
5-11
5-4 Sending Commands in Multi-head Mode
Sending commands in multi-head mode is identical to sending commands in multi-drop link
mode.
Refer to "4-3 Sending Commands to BL/SR/RF Series Devices" (Page 4-13) for more information.
This section the basics will be outlined here.
Sending Commands to BL/SR/RF Series Devices
This data communication format does not append the ID number of the BL/SR/RF Series device.
However, the ID number of the BL/SR/RF Series device to which the command is being sent must
be included in the command, as shown below.
 BL/SR/RF Series device commands
 Response
[mm= 01 to 31 (ID number)]
Refer to "4-3 Sending Commands to BL/SR/RF Series Devices" (Page 4-13) for more
information on formats.
Use the specific ID polling command before using the read test mode.
"Turn auto-polling on for a specific ID" (Page 4-18)
Make sure to turn this off after use.
N-410 Direct Control Commands and Setting Commands
N-410 commands are the same as in multi-drop link mode.
 N-410 commands
 Response
Refer to "4-4 N-410 Direct Control Commands" (Page 4-15) or "4-5 N-410 Setting Commands"
(Page 4-22) for more information on formats.
T mm -Header DelimiterSerial command%
T mm -Header DelimiterResponse%
Note
Header
DelimiterCommand
Header
DelimiterResponse