Owner's manual
Table Of Contents
- N-400 User's Manual
- Software License Agreement
- Safety Precautions
- Warnings and Cautions Specific to the N-400
- List of Package Contents
- Contents
- Chapter 1 Overview of the N-400
- Chapter 2 Installation Procedure
- Chapter 3 N-400 Setup Procedure
- Chapter 4 Multi-Drop Link Mode Control Procedure
- Chapter 5 Multi-Head Mode Control Procedure
- Chapter 6 PLC Link
- Appendices
- WARRANTIES AND DISCLAIMERS:
Chapter 4 Multi-Drop Link Mode Control Procedure
76
4
■ Response error codes
If an incorrect setup command is sent to the N-400, the N-400 sends back the
cause of the error (error code).
Error response: ERR** (** is the error code.)
Error code Cause of error
00 Undefined command
01 The ID number exceeds the setting range.
02 The number included in the command does not correspond to anything.
05 The number included in the command is too long.
06 “hhh...” is too short.
07 “N” is any value other than “0” or “1”.
08 “n” exceeds the setting range.
09 “nnn” or “nn” exceeds the setting range.
10 “hhh...” is not specified as HEX codes (hexadecimal numbers).
11 Setting “hhh... = FF” is impossible.
12 “hhh...” exceeds the specified number of characters.
14 The data stored in the EEPROM may be corrupted. Initialize the settings.
15 The area storing the initial settings is incorrect.