Owner's manual

Chapter 3 N-400 Setup Procedure
49
3
4. If the settings were successfully sent to the N-400, the following message
appears.
If the host computer failed to send the data to the N-400, the following message
appears.
If this message is displayed, check the following points:
• Check that [COM PORT] is set to the values listed in step 1. when the N-
400 displays “S0 (50)”.
• Check that the power to the N-400 is ON.
• Check that the RS-232C cable pin assignment of the N-400 is the same as
that of the host computer.
5. After the settings are sent, press the N-400 test switch once to reset the “S0
(50)” condition. (If the N-400 does not display “S0 (50)”, you do not need to
press the test switch. )
When the N-400 displays “00”, the sending procedure is completed. (The
communication parameters of the N-400 are set to the updated settings.)