Owner's manual
Table Of Contents
- N-400 User's Manual
- Software License Agreement
- Safety Precautions
- Warnings and Cautions Specific to the N-400
- List of Package Contents
- Contents
- Chapter 1 Overview of the N-400
- Chapter 2 Installation Procedure
- Chapter 3 N-400 Setup Procedure
- Chapter 4 Multi-Drop Link Mode Control Procedure
- Chapter 5 Multi-Head Mode Control Procedure
- Chapter 6 PLC Link
- Appendices
- WARRANTIES AND DISCLAIMERS:
Chapter 3 N-400 Setup Procedure
32
3
3.1 Installing Setup Software
The N-400 includes the setup software for the Windows version only.
The operating environments and the procedure for installing this setup software
are described below.
■ Hardware requirments
• IBM PC/AT 100% compatible
CPU: 80386 or higher
Memory: 4 MB or more
Floppy disk drive: 3.5 inch floppy disk drive (1.44 Mb compatible)
Serial port: A minimum of one RS-232C port is required.
■ OS requirements
• MS-Windows 3.1 or MS-Windows 95
Installation procedure
1. Insert the N-400 setup software system disk into the floppy drive.
2. Perform the following procedure.
•Windows 3.1:
Execute “Run” in the icon menu of the program manager.
•Windows 95:
Select “Run” from the "Start" menu.
3. Run the “SETUP” file from the floppy disk drive.
(This step is common to both the Windows 3.1 and Windows 95.)
Type in as follows:
A: \SETUP