Owner's manual
Table Of Contents
- N-400 User's Manual
- Software License Agreement
- Safety Precautions
- Warnings and Cautions Specific to the N-400
- List of Package Contents
- Contents
- Chapter 1 Overview of the N-400
- Chapter 2 Installation Procedure
- Chapter 3 N-400 Setup Procedure
- Chapter 4 Multi-Drop Link Mode Control Procedure
- Chapter 5 Multi-Head Mode Control Procedure
- Chapter 6 PLC Link
- Appendices
- WARRANTIES AND DISCLAIMERS:
Chapter 2 Installation Procedure
28
2
SD RD
SD
TERMINATOR
RD
CS RS
TEST
RS-232C
RS-455
POWER TIMING
N-400
ON
OFF
40
100
4 x ø5
mounting hole
SD RD
SD
TERMINATOR
RD
CS RS
TEST
RS-232C
RS-455
POWER TIMING
N-400
ON
OFF
POWER SD RD
5.9
43.2
63.2
75
5.9
4 x ø5
mounting hole
2.6.2 Mounting N-400
To mount the N-400, you can use one of the following two methods:
Direct mounting
Pull the brackets provided at four positions on the rear of the N-400, and fix them
with screws.
DIN-rail mounting
To mount the N-400 on a DIN-rail, press the unit against the DIN rail until it clicks.
To remove the unit, pull the hook in the direction indicated by arrow.
2.6.3 Mounting N-48
To mount the N-48, use the mounting hole.