Owner's manual
Table Of Contents
- N-400 User's Manual
- Software License Agreement
- Safety Precautions
- Warnings and Cautions Specific to the N-400
- List of Package Contents
- Contents
- Chapter 1 Overview of the N-400
- Chapter 2 Installation Procedure
- Chapter 3 N-400 Setup Procedure
- Chapter 4 Multi-Drop Link Mode Control Procedure
- Chapter 5 Multi-Head Mode Control Procedure
- Chapter 6 PLC Link
- Appendices
- WARRANTIES AND DISCLAIMERS:
Chapter 2 Installation Procedure
22
2
2.4.3 Setting BL-U1 DIP switches
Switch the interface setting to “RS-485 multi-drop” using the BL-U1 DIP switches.
Switch the RS-485 terminator according to p. 25.
* The figure on the left shows the default settings.
OFF
ON
123456
DIP Switch No. 1 2 3 4 5 6
Interface selection RS-232C ON OFF OFF
RS-422A OFF ON OFF
RS-485 multidrop OFF OFF ON
RS-422A terminator OFF OFF
(Termination resistance: 100 Ω)ON ON
RS-485 terminator OFF OFF
(Termination resistance: 100 Ω)ON ON
Selection of READER port ON or OFF according
CS control method to the RS-232C port OFF
CS signal status.
Normally ON ON