Owner manual

LS-Navigator-M-NO5-E

5-12

5-7

Setting RS-232C Communication Conditions

This section describes how to set the same RS-232C communication conditions on LS-

Navigator as used on the connected controller.

The software can check the following RS-

232C communication conditions for the

controller environment settings.

• Baud rate ([BAUDRATE])

• Stop bit ([STOPBIT])

• Data length ([D-LENGTH])

• Data mode ([D-MODE])

• Data send mode ([D-SEND])

Use the following procedure to check the RS-

232C communication conditions.

For the LS-7600/7500 series

Press and hold the [ESCAPE] button while in

[Setting] mode for at least three seconds, and then

check the settings in the [Environment settings]

menu that appears.

For more details, see “Environment Settings” in

the “User’s Manual” for the LS-7600/7500 series.

For the LS-7000 series

Press the [FUNC] key once during [Program]

view, and then check the settings in the [RS-

232C] view that appears.

For more details, see “RS-232C” in the “User’s

Manual” for the LS-7000 series.

Select [Communication settings] from the

[Settings] menu.

Or click on the [Com settings] icon on the

tool bar.

The [Communication settings] dialog appears.