Owner manual

3-4
LK-H1W-M-NO3-E
3 Operations and Functions of Software
3
Flow of Operations
The procedure to set the Head-A signal to be output from OUT1 when the "LK-Navigator"
is started up for the first time after purchase, is described below.
Connect the controller to a PC using the RS-232C cable or USB cable.
Start up the controller first, then start up the PC.
Start up LK-Navigator.
Select [Start up with the default values] from the [Select the settings to be dis-
played at startup] window.
Select the Program No.
Set the [Common Settings].
Refer to "Connecting the Controller to a PC" (page 2-2).
Refer to "Start and Quit" (page 2-11).
Refer to "Start and Quit" (page 2-11).
Refer to "Setting the Programs" (page 3-26).
Refer to "Common Settings" (page 3-17).