Manual

2. Overview and Operation

Switch comment screen

The customized switches (F1 to F4) are assigned to the following four relays.

Each relay turns on only while the corresponding switch is pressed. When several

switches are pressed simultaneously, one of the relays for the switches turns on.

• When a contact comment is set to a relay, the comment is displayed (up to 17

characters). When no contact comment is set, the device number is displayed.

➮

Refer to "Displaying contact comment" on page 29.

• The customized switches can be used in all modes.

Note 1: The speed required to capture the ON/OFF status of the customized

switches depends on the scan time, communication time, and internal processing

time. If the switches are operated at a speed faster than the capture speed, the KV

unit does not recognize the operation properly.

Note 2: If the modular cable is disconnected while a customized switch is pressed,

the relay corresponding to the switch remains on.

Lamp comment screen

The customized lamps (1 to 4) are assigned to the following four relays.

Each lamp illuminates only while the corresponding relay is ON.

• When a contact comment is set to a relay, the comment is displayed (up to 15

characters). When no contact comment is set, the device number is displayed.

➮

Refer to "Displaying contact comment" on page 29.

• The customized lamps can be used in all modes.

dezimotsuC

pmal

.oNyaleR

1pmaL 4052YLR

2pmaL 5052YLR

3pmaL 6052YLR

4pmaL 7052YLR