User Manual

8
GT-M-E
■
Basic setting mode
You can set the following functions in the basic setting mode.
■
Additional function setting mode
You can set the following functions in the additional function setting mode.
No. Item Description
Measurement
direction
change
Set the " Normal " or " Reverse " when the
spindle of the sensor head is inserted.
Lever ratio Set the ratio of the detected value.
Output format
Set "ON (N.O.)" or "OFF (N.C.)" for output
judgment.
Number of
display digits
Set the number of display digits.
Hysteresis Set the hysteresis value.
Input line
function 1
Set the input line function 1 (Violet).
Input line
function 2
Set the input line function 2 (Pink/Violet).
OFF
 Calculation mode
*The calculation mode will appear only when an expansion unit(s) is added.
Max. value
Min. value
Evenness
Average
Reference difference
Tw is t
Curve
Thickness
MODE
MODE
Normal
 Measurement direction change
(press and hold the [MODE] + [SET] buttons in the main screen)
Reverse
Display for entering the setting value
 Lever ratio
MODE
N.O.
 Output format
N.C.
MODE
Display for entering the setting value
 Number of display digits
MODE
No. Item Description
Preset
memory
Set the memory status for "zero-point
correction".
Power-saving
function (ECO)
To decrease the power consumption or not to
display the numerical value, set this function.
Jam detection
function
When the spindle does not return due to an
undetected event in external timing input, set
to detect such an event as an error.
Check point
setting
Set the point to detect as an error for .
Display filter
function
Set the filter to stabilize the display.
Display for entering the setting value
 Hysteresis
MODE
Bank A
Reset input
 Input line function 1
MODE
Timing input
Bank B
 Input line function 2
MODE
YES
 Preset memory (press and hold the [MODE] + left buttons in the main screen)
NO
MODE
OFF
 Power-saving function
ECO Half
ECO All
MODE
OFF
 Jam detection function
ON
User
MODE
Available to set only when t-in is selected in [ Timing type].