User guide

3-3 Explicit Messaging
3-27
3
Communicating with the IL Series
- DeviceNet Compatible Network Unit DL-DN1 User’s Manual (IL) -
*1 The function of DL-DN1 only, which responds to explicit messaging synchro-
nously with I/O communication. This function does not guarantee synchronism
of the whole system, including PLC or master equipment.
0
69 to 6B System reserved
6C Error ID number Error details.
If there are errors with multiple ID
numbers, the error information for the
smallest ID number is output.
RUINT0
Error information list
(page 3-8)
6D Error code R UINT0
6E
Warning ID
number
Not used with the IL Series.
RUINT0
−
6F Warning code R UINT0
70 to 73 System reserved
74 HIGH
The HIGH state is output by assigning
sensor amplifiers (ID 01 to ID 15) bits
0 - 14.
RWORD0
0: OFF
1: ON
75 LOW
The LOW state is output by assigning
sensor amplifiers (ID 01 to ID 15) bits
0 - 14.
RWORD0
0: OFF
1: ON
76 GO
The GO state is output by assigning
sensor amplifiers (ID 01 to ID 15) bits
0 - 14.
RWORD0
0: OFF
1: ON
77 Alarm output
The alarm output is output by assign-
ing sensor amplifiers (ID 01 to ID 15)
bits 0 - 14.
RWORD0
0: OFF
1: ON
78 (Not used)
79 to 8C System reserved
8D
Judgment value
"invalid"
If the judgmentd values for sensor
amplifiers (ID 01 to ID 15) are "invalid"
(-----), they are output by assigning
them to bits 0 - 14.
RWORD0
0: Normal value
1: Invalid
8E
Judgment value
"under"
If the judgmentd values for sensor
amplifiers (ID 01 to ID 15) are "under,"
they are output by assigning them to
bits 0 - 14.
RWORD0
0: Normal value
1: Under
8F
Judgment value
"over"
If the judgmentd values for sensor
amplifiers (ID 01 to ID 15) are "over,"
they are output by assigning them to
bits 0 - 14.
RWORD0
0: Normal value
1: Over
90
Current value ID
01
Reads the current value of ID 01.
Same as the current value used in I/O
communication.
R DINT 0
-2147483648 to
2147483647
~
9E
Current value ID
15
Reads the current value of ID 15.
Same as the current value used in I/O
communication.
9F to B0 System reserved
B1
Number of
sensor amplifier
units connected
Reads the number of connected sen-
sor amplifiers.
RUINT 0 1 to 15
B2 to B3 System reserved
B4
Explicit message
response method
If synchronous response is used,
response occurs synchronously with I/
O communication.*1
R/W UINT0
0: Immediate
response
1: Synchronous
response
B5 to B9 System reserved
BA
Operating mode
switch status
Set status of operating mode setting
switch: switch 1 (LSB) to switch 4
(MSB)
RUINT0
0 to 15
0: OFF, 1: ON
InstID
(DEC)
AttrID
(HEX)
Name Description Attribute
Data
type
Default
value
Parameter range