Owner's manual

KEYENCE CORPORATION. Vision System Division
‐ 4 ‐ www.keyence.com
✎Configuring the KV Series Settings
2
1
Enter the "Project name", select the "PLC model", and then press "OK".
Start KV STUDIO with the PLC connected to the computer, and select [File] > [New project].
3
Select [Read unit setting] in the "Confirm unit setting information" dialog box.
4
In the workspace, click the link unit or CPU unit that will be connected to the CV-X via Ethernet to start "Unit
Editor", and set up the IP address and Port No. of the KV Series on the "Setup unit(2)" tab.
IP address: 192.168.0.20* Enter the "IP Address" set
in step 2 on the previous page.
Subnet mask: 255.255.255.0
Port No. (VT): 8502
* When multiple devices are
connected to KV, they can have the same Port No.