Owner's manual

355GB

KEYENCE CORPORATION. Vision System Division

‐ 3 ‐ www.keyence.com

1. Establishing the PLC-Link (Ethernet PLC-Link) [Keyence KV Series]

✎Checking the Global Settings of the CV-X Series

Select [Global] > [Communications & I/O] > [Network] on the controller, and then configure the network (Ethernet)

settings for the CV-X.

Select "OK" to close the "Network Settings" screen, select [Global] > [Communications & I/O] > [PLC-Link], and then

configure the PLC-Link settings.

Select "OK" to close the "PLC-Link" setting screen and then restart the controller.

Configure the network settings for CV‐X.

IP Address: 192.168.0.10

Subnet Mask: 255.255.255.0

Default Gateway: 0.0.0.0

Configure the PLC‐Link settings.

Mode: PLC- Link (Ethernet)

PLC Type: KV Series

IP Address: 192.168.0.20

Port: 8502

Resend Time (ms): 10000

* "IP Address" above indicates the one for

the KV Series that will be connected. Set an

address whose fourth number differs from

that of the "Controller IP Address" set in step

Decimal Point: Fixed- point

Command Execute Event: Polling

Command Complete Address (bit): 00003

Command Address: 00100

Command Result Address: 00200

Result Output Address: 00500

Result Ready Address (bit): 00000

Result Ack Address (bit): 00001

Acknowledge result output completion:

Checked

Enable Handshake: Unchecked

This section describes how to establish the PLC‐Link.

[Important] If it fails, establish a one-to-one connection between the PLC and CV-X, and follow this manual to configure the settings

and check the operations.

Confirm that it operates properly, and change settings if necessary.

Be careful not to use the

same IP address.