Users Manual

ManualsBrandsKEYENCE ManualsInstrumentsHandheld Terminal

BT-A500 IM GB

 Precautions on Bluetooth

 FCC Regulations BT-A500GA only

• This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions; (1) This device may not cause harmful interface, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

• Application regulation

FCC Part 15 Subpart B Class A

FCC Part 15 Subpart C

FCC Part 15 Subpart E

• The available scientific evidence does not show that any health problems

are

associated with using low power wireless devices. There is no proof, however, that

these low power wireless devices are absolutely safe. Low power Wireless devices

emit low levels of radio frequency energy (RF) in the microwave range while being

used. Whereas high levels of RF can produce health effects (by heating tissue),

exposure of low-level RF that does not produce heating effects causes no known

adverse health effects. Many studies of low-level RF exposures have not found any

biological effects. Some studies have suggested that some biological effects might

occur, but such findings have not been confirmed by additional research. The BT-

A500GA has been tested and found to comply with FCC radiation exposure limits set

forth for an uncontrolled environment and meets the FCC radio frequency (RF)

Exposure Guidelines.

• Compliance with FCC requirement

Data transmission is always initiated by software, which is the passed down through the

MAC, through the digital and analog baseband, and finally to the RF chip. Several

special packets are initiated by the MAC. These are the only ways the digital baseband

portion will turn on the RF transmitter, which it then turns off at the end of the packet.

Therefore, the transmitter will be on only while one of the aforementioned packets is

being transmitted. In other words, this device automatically discontinue transmission in

case of either absence of information to transmit or operational failure.

• 5.15-5.35GHz band is restricted to indoor operations only.

• Frequency Tolerance: ±25ppm

 ISED Regulations BT-A500GA only

The BT-A500GA complies with the following regulations specified by the ISED.

• Applicable regulation

ICES-003

RSS-247

• The available scientific evidence does not show that any health problems are

associated with using low power wireless devices. There is no proof, however, that

these low power wireless devices are absolutely safe. Low power Wireless devices emit

low levels of radio frequency energy (RF) in the microwave range while being used.

Whereas high levels of RF can produce health effects (by heating tissue), exposure of

low-level RF that does not produce heating effects causes no known adverse health

effects. Many studies of low-level RF exposures have not found any biological effects.

Some studies have suggested that some biological effects might occur, but such

findings have not been confirmed by additional research. The BT-A500GA has been

tested and found to comply with IC radiation exposure limits set forth for an

uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure

rules.

• 5150-5350 MHz band is restricted to indoor operation only.

High-power radars are allocated as primary users (i.e. priority users) of the bands

5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference

and/or damage to LE-LAN devices.

• Data transmission is always initiated by software, which is the passed down through the

MAC, through the digital and analog baseband, and finally to the RF chip. Several

special packets are initiated by the MAC. These are the only ways the digital baseband

portion will turn on the RF transmitter, which it then turns off at the end of the packet.

Therefore, the transmitter will be on only while one of the aforementioned packets is

being transmitted. In other words, this device automatically discontinue transmission in

case of either absence of information to transmit or operational failure.

• Les connaissances scientifiques dont nous disposons n’ont mis en évidence aucun

problème de santé associé à l’usage des appareils sans fil à faible puissance. Nous ne

sommes cependant pas en mesure de prouver que ces appareils sans fil à faible

puissance sont entièrement sans danger. Les appareils sans fil à faible puissance

émettent une énergie radioélectrique (RF) très faible dans le spectre des micro-ondes

lorsqu’ils sont utilisés. Alors qu’une dose élevée de RF peut avoir des effets sur la santé

(en chauffant les tissus), l’exposition à de faibles RF qui ne produisent pas de chaleur

n’a pas de mauvais effets connus sur la santé. De nombreuses études ont été menées

sur les expositions aux RF faibles et n’ont découvert aucun effet biologique. Certaines

études ont suggéré qu’il pouvait y avoir certains effets biologiques, mais ces résultats

n’ont pas été confirmés par des recherches supplémentaires. Le BT-A500GA a été

testé et jugé conforme aux limites d’exposition aux rayonnements énoncées pour un

environnement non contrôlé et respecte les règles d’exposition aux fréquences

radioélectriques (RF) CNR-102 de l’IC.

• La bande 5150-5350 MHz est restreinte à une utilisation à l’intérieur seulement. Les

radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu'ils ont la

priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz, et ces radars pourraient

causer du brouillage et/ou des dommages aux dispositifs LAN-EL.

• La transmission des données est toujours initiée par le logiciel, puis les données sont

transmises par l'intermédiaire du MAC, par la bande de base numérique et analogique

et, enfin, à la puce RF. Plusieurs paquets spéciaux sont initiés par le MAC. Ce sont les

seuls moyens pour qu'une partie de la bande de base numérique active l'émetteur RF,

puis désactive celui-ci à la fin du paquet. En conséquence, l'émetteur reste uniquement

activé lors de la transmission d'un des paquets susmentionnés. En d'autres termes, ce

dispositif interrompt automatiquement toute transmission en cas d'absence

d'information à transmettre ou de défaillance.

Remove the main battery of the BT-A500 Series near locations where

using wireless devices is banned at medical institutions or near

electric devices for medical purposes. Carry and use the product away

from an implanted cardiac pacemaker.

• Depending on the environment, communication may be impossible.

Before starting actual operation, be sure to test the operation.

• If this product is used near devices with the same frequency band,

such as a wireless LAN device, microwave oven, heating equipment

for industrial use, high-frequency equipment for medical use, etc.,

radio wave interference may occur and the communication speed

will become slow or communication may become impossible.

• If a wireless LAN and Bluetooth are used at the same time, radio

wave interference may occur and the communication speed will

become slow or communication may be interrupted. If there is

communication failure, stop using either the wireless LAN or

Bluetooth.

• Communication may be impossible at locations near metallic

objects, locations surrounded with metallic walls or where there is a

lot of metallic powder.

• Possible communication distance is approx. 10 m of vision,

however, even within 10 m, communication may become impossible

depending on the environment. Check the communication

availability before using.

• With the frequency band for this unit, premise radio stations (license

required), specified low power radio stations (license not required)

and amateur radio stations (license required) for identifying mobile

objects used for industrial, scientific and medical equipment or

factory production lines are operating.

1. Before using this unit, be sure to check that premise radio

stations, specified low power radio stations and amateur radio

stations for identifying mobile objects are not operating in the

vicinity.

2. If radio wave interference occurs from the this unit against

premise radio stations for identifying mobile objects, change

the usable frequency immediately or stop the electric wave

generation, and then contact the below phone number in

regard to taking necessary measures (e.g. setting a partition) to

avoid interference.

[Thai] BT-A500/A500G only

This telecommunication equipment is in compliance with NBTC

requirements.

[Singapore] BT-A500/A500G/A500GM only

This telecommunication equipment is in compliance with the

regulation requirement for Singapore.

WARNING

Important

Complies with

IMDA Standards

DA104049

Note: This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his/her own

expense.

• FCC CAUTION

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate the equipment.

• This transmitter must not be co-located or operated in conjunction

with any other antenna or transmitter.

• This device complies with Industry Canada’s licence-exempt RSSs.

Operation is subject to the following two conditions: (1) this device

may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired

operation of the device.

• Le présent appareil est conforme aux CNR d'Industrie Canada

applicables aux appareils radio exempts de licence. L'exploitation

est autorisée aux deux conditions suivantes : (1) l'appareil ne doit

pas produire de brouillage, et (2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même si le brouillage

est susceptible d'en compromettre le fonctionnement.

CAUTION

· Regulatory information page is located at: [settings]: [About phone]: [Regulatory]