User's Manual

2-11
2
First Steps
2-4 Charging the BL-N90/N90K
The communication unit is used to charge the BL-N90/N90K.
b How to charge
Procedure
1 Connect the communication unit to your computer using the appropriate connection
method, and make sure both sides are powered on.
For details on connection methods, refer to "Connecting the Communication Unit" on page 2-5.
2 Set the BL-N90/N90K into the communication unit securely, to ensure that the charging
terminals stay in place.
As the unit begins to charge, the yellow LED on the scanner begins to flash .
Charging is complete once the yellow LED stops blinking .
A full charge takes approximately 4 hours.
Note
The barcode reader is shipped with zero charge. Please charge the device before use.
The barcode reader may be used to scan ( page 2-13) after a charge of just 10
minutes.
Note
•
Please periodically clean the charging terminals on the BL-N90/N90K and the
communication unit ( "Maintenance" (Page 6)).
Dirt in the terminals may interfere with charging.
• The BL-N90/N90K can be configured to sound an alarm when it is unable to charge
properly, such as when the charging terminals are misaligned.
To computer