User's Manual

CHAPTER 2: INSTALLATION AND SETUPS
2.1 HARDWARE INSTALLATION:
Firstly, please switch off your computer system and then according to the
keyboard’s receiver connector (PS2 or USB), connect it to your computer system.
At the same time, please make sure that the frequency channel has been adjusted to
CH1 (factory setting). You then remove the battery cover keyboard featured under
the keyboard itself and check if the frequency channel has also been adjusted CH1.
After all those procedures have been done, just insert 3 AA batteries into the
keyboard to complete the hardware installation.
(Remark: You may also set both of the frequency channels to CH2 but never with a
situation in which both of the frequency channels are varied to each other, as it
might end up with the abnormality of the keyboard operation.)
2.2 SOFTWARE INSTALLATION
Inside the package of KF-9801, we have enclosed a disk called MULTIMEDIA
KEYBOARD to support the operating systems of Windows 95/98/NT/2000/ME.
This disk not only installs the driver for the keyboard but also provides end-users
many extra functions. Once the installation of the hardware has been set, you can
then begin the process of software installation. Firstly, please insert the disk into the
disk drive and carry out A:\SETUP.EXE file.
Step1: You will firstly see the installation icon asking you the path in which the
duplication of the files is going to be located. After you have selected the location,
you then press OK. Now you are suppose to see 5 folders been created in the
location that you have selected.
Step2: According to the needs of your operating system, select a proper folder
name and then carry out “SETUP.EXE”
Step3: You can then install or change the formula to specific menu according to the
actual demands.
Step 4: When the files have completed the duplication process, please restart your
computer in order to finish your setup procedures.