Owners manual

IR Remote Control

The IR Remote Control included with KD-MLV4x2Pro provides

convenient but limited control of the switching features and unit setup.

There are 3 main groups of controls:

› Group for output 1 source and 2K / 4K output resolution select

› Group for output 2 source and 2K / 4K output resolution select

› Group for device select buttons

› Additionally, there are discrete power on and off buttons and

function buttons R1, R2, and R3.

» The remote is powered by a CR2025 type battery

» The circular IR sensor accepts control signals from the

remote control. The sensor is located in the center of the

front panel.

Switching via IR

To execute a switching command, press the desired source select

button within the desired output button group.

Multi-View Modes via IR

1080p (2K) Multi-View presets can be called using the IR remote by pressing the following remote

button sequence:

› R1, 0-9

1-9

= Desired preset, where 1-5 are, be default, Quadrant, Top, Bottom, Left, Right.

» All presets may be overwritten using the Web Control Interface, RS-232,

or TCP-IP terminal

= Input Swap

Quad-View/Multi-View Audio Select via IR

You may select the desired audio source if in Quad or Multi-View modes with the following two-

button remote sequence:

› R3, A

= Input Select button from Output 1 or Output 2 button group

EDID Control via IR

KD-MLV4x2Pro has a built-in library of 5 EDID settings and the ability to copy EDID data from any

output speciﬁed via IR, RS-232, and TCP-IP. EDID Control setup via RS-232 and TCP-IP can be

found in the RS-232 Commands and Protocol TCP-IP Setup and Control sections.