Owners manual

1080p(2K) Multi-View mode select (5 buttons) and Input Swap (1 button)

› Pressing any of the 5 Multi-View mode select buttons will activate both outputs to

simultaneously enter the selected screen layout

IMPORTANT:

Selecting 2K Multi-View mode results in linking of the two KD-MLV4x2Pro

outputs (showing same image at the same time).

› The 5 layouts are, by default:

1. Quadrant

2. Top

3. Bottom

4. Left

5. Right

› If desired, the layouts can be over-written via the Web Control Interface, RS-232, or TCP-IP, by

saving to the KD-MLV4x2Pro’s preset bank

› Resetting the KD-MLV4x2Pro to factory default will restore these 5 layouts in the preset bank as

layouts 1-5, respectively.

› The

Input Swap

button serves 2 purposes:

» 1. If used in standard 4x2 matrix, full-screen mode, pressing Input Swap will simultaneously

and synchronously switch both outputs:

» 2. If used in Multi-View mode, pressing Input Swap rotates source content of the 4 inputs

through the 4 windows:

› Conﬁrmation of 2K multi-view mode and respective input-type for sources (in parenthesis) is

shown on the LCD screen:

» OUT 1: 2K MV (VHHH)

» OUT 2: 2K MV (VHHH)

Factory Default Reset via the Front panel

To reset the unit to Factory Default settings, simultaneously press and hold the HDMI Input-Type

Select button and Input Swap button for approximately 10 seconds

› Default Settings:

» Unit Address is 00

» Output 1 is set to Input 1

» Output 2 is set to Input 1

» EDID to all inputs is Default 2 (1080p, 2ch audio)

» All other internal parameters set to default